Turboelectric Distributed Propulsion System Modelling for Hybrid-Wing-Body Aircraft

Abstract

(ABSTRACT) In 2005, NASA released plans of next generation commercial airplane for 2030, with a crossdisciplinary effort on: reduced fuel consumption, aviation reliability, fundamental noise reduction and shorter take-off length. Meeting these requirements will need a fundamental shift in aircraft and engine design. Turboelectric distributed propulsion system was chosen to achieve these targets. Different from traditional turbofan, distributed propulsion system employs a large number of fans embedded on upper surface of the airframe and two turbogenerators at wing tip. This novel configuration benefits from boundary layer ingestion and distributed fans to achieve higher bypass ratio but lower fuel burn. The N3-X hybrid-wing-body is used as a baseline aircraft for the study. This paper gives basic simulation methods, as well as computational models for turboelectric distributed propulsion system. Initially, a boundary layer ingesting model has been built from computational results for embedded propulsor at different inlet conditions. In a further step, a weight estimation model of propulsors was concluded to estimate propulsors’ weight and size. Then, thermal cycle model was built to calculate engine’s performance at both design point and off design conditions. Finally, effects of boundary layer ingestion on the propulsion system were examined. The boundary layer ingesting model showed mass-average inlet pressure and Mach number are function of flight Mach number and fan inlet mass flow, on the N3-X airframe. The weight estimation model shows the overall system weight decreased with increased number of propulsors, which also caused total inlet width of propulsors increasing. So for a given total inlet width, the propulsor should be used as many as possible to reduce weight. Thermal cycle results show that fan shaft speed should be chosen as high as possible before reaching the fan tip speed limitation, and fan pressure ratio (FPR) between 1.3 and 1.35 yields minimum thrust specific fuel consumption (TSFC) at the aerodynamic design point. A fan pressure ratio of 1.3 is chosen for its potential effects on noise control. In the end, a turboelectric distributed engine was simulated to satisfy NASA N+3 subsonic commercial airplane goals.