SAE technical papers on CD-ROM/SAE technical paper series · 2010 · 69 citations · 14 references
EngineeringAutomotive EngineeringElectrical EngineeringHeat TransferPowertrain EngineeringThermodynamicsBattery Thermal ManagementElectric PowertrainsElectric Vehicle Thermal ManagementThermal DesignThermal ManagementThermoelectric MaterialsThermal Management System IntegrationThermoelectric Energy ConversionThermoelectric Energy HarvestingThermoelectric Module DesignThermoelectric Properties
<div class="section abstract"><div class="htmlview paragraph">The promise of thermo-electric (TE) technology in vehicles is a low maintenance solid state device for power generation. The Thermo-Electric Generator (TEG) will be located in the exhaust system and will make use of an energy flow between the warmer exhaust gas and the external environment. The potential to make use of an otherwise wasted flow of energy means that the overall system efficiency can be improved substantially.</div> <div class="htmlview paragraph">One of the barriers to a successful application of the technology is the device efficiency. The TE properties of even the most advanced materials are still not sufficient for a practical, cost effective device. However the rate of development is such that practical devices are likely to be available within the next fifteen years.</div> <div class="htmlview paragraph"> In a previous paper [ <span class="xref">1</span> ], the potential for such a device was shown through an integrated vehicle simulation and TEG model. It was concluded that with current materials and construction technology a device could be produced to replace the alternator of a super-mini type passenger car (typified by the Ford of Europe Fiesta). </div> <div class="htmlview paragraph"> Further modeling of TEGs and a supporting experimental program has been used to validate the heat transfer model and the performance of the TEG. Several passenger vehicles were modeled, predicting a fuel saving of 3.9 - 4.7%. TEGs for passenger buses will become a viable alternative to alternators with a payback period of less than three years, once modules with a figure-of-merit ( <i>ZT</i> ) of 3 and a unit cost half of those used in the analysis. A transit bus was modeled and tested on several drive cycles. The results suggested that for a fuel saving of 7.4% with a payback of 6 years could be achieved with current TE materials and costs. </div> <div class="htmlview paragraph"> Note: Abbreviations and symbols are defined in the <span class="xref">appendix</span> . </div></div>
14
High-Thermoelectric Performance of Nanostructured Bismuth Antimony Telluride Bulk Alloys
Bed Poudel, Qing Hao, Yi Ma et al. · Science · 2008 · 5.5K citations
Natural Sciences, Materials Engineering, Materials Science +16
New Directions for Low‐Dimensional Thermoelectric Materials
M. S. Dresselhaus, Gang Chen, Ming Tang et al. · Advanced Materials · 2007 · 4K citations
Peierls distortion as a route to high thermoelectric performance in In4Se3-δ crystals
Jong‐Soo Rhyee, Kyu Hyoung Lee, Sang Mock Lee et al. · Nature · 2009 · 544 citations