Wireless Power Transfer with Concurrent 200 kHz and 6.78 MHz Operation in a Single Transmitter Device

Abstract

This paper proposes a wireless power transfer (WPT) transmitter that can concurrently operate at 200 kHz and 6.78 MHz in order to simultaneously power two receivers operating with different frequency standards. Unlike a dual-resonant single-coil design, the use of two separate coils decouples the design for one frequency from the other, enabling independent selection of inductance and Q-factor to simultaneously maximize efficiency at both frequencies. The two coils then support separate coil drivers, enabling concurrent multistandard operation. Dual-band operation is achieved in the same area as an equivalent single-band design by placing a low-frequency coil within the geometry of a high-frequency coil, where the outer diameter of inner coil is sacrificed only by 1.2 cm in a 12.5 × 8.9-cm <sup xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">2</sup> design. Circuit analysis is presented to identify the eddy current between the two Tx coils and its associated loss, after which an eddy-current filter design is proposed. To validate the proposed design, a dual-mode transmitter, along with two receivers designed at 6.78 MHz and 200 kHz, respectively, have been fabricated. At 25-mm separation, the system is able to simultaneously deliver 9 and 7.4 W with efficiencies of 78% and 70.6% at 6.78 MHz and 200 kHz, respectively.