Soc. Pet. Eng. AIME, Pap.; (United States) · 1984 · 16 citations · 0 references
EngineeringCivil EngineeringHydraulicsReservoir EngineeringWell TestingGas Well TestingPressure Drop PredictionWell HydraulicsWell ModelingWell Performance AnalysisWellbore HydraulicsFlow Regime PredictionPressure DropPressure Drop BehaviorPressure Drop MeasurementPressure-drop ModelingTwo-phase Flow ModelingTwo-phase Flow RegimesTwo-phase Flow Simulation
A considerable number of deep (10,000 plus feet) high volume gas wells in Northern Germany show signs of increasing water production (up to 125 BBL/MMscf). To predict well behavior and optimize recovery from these wells it is not only necessary that one is able to realistically describe the two-phase flow in the reservoir but also flow in the wellbore up the tubing. In particular one must be able to: - Predict the pressure drop in the tubing with reasonable accuracy, and - estimate the benefit from operational changes such as changing tubing size, etc. Since none of the available calculation procedures was found capable of handling the problem, an extensive gas well-testing program was initiated and actual two-phase (gas/water) pressure drops measured in the field for a wide range of operating parameters. The evaluation of the test results and comparison with calculated pressure drops provide the following conclusions: Unmodified, the multi-flow-regime calculation procedures significantly overpredict the actual tubing pressure drop in reasonably high to high water-cut gas wells. Unmodified, the much simpler no-flow-regime calculation procedures, while underpredicting the actual pressure drop, provided far better estimates over the range of parameters considered. In using the multi-flow-regime procedures, pressure drop calculations assumingmore » mist flow yielded very accurate values for the pressure drop over a much wider range of flow parameters than suggested by the available flow regime definitions. Using the available data to redefine the flow regime boundary separating the mist from the slug flow regime, the multi-flow-regime pressure drop calculation procedures could be significantly improved.« less