JES. Journal of Engineering Sciences/JES. Journal of engineering sciences · 2013 · 11 citations · 16 references
EngineeringManufacturing EngineeringMaterials EngineeringDrawingFinite Element AnalysisMechanical Behavior Of MaterialsMetal FabricationMetal FormingMetalworking TechnologySheet Metal FabricationSheet Metal WorkSolid Mechanics ApplicationsDeep DrawingDie DesignDie Stress AnalysisMaterial DrawabilitySheet Metal FormingSheet Metal PunchingTensile DeformationTensile Strain
This paper introduces a new technique for deep drawing of elliptic cups through a conical die without blank holder or draw beads. In this technique an elliptical-cup is produced by pushing a circular blank using a flat-headed elliptic punch through a conical die with an elliptic aperture in a single stroke. A 3D parametric finite element (FE) model was built using the commercial FE-package ANSYS/APDL. Effects of die and punch geometry including, half-cone angle, die fillet radius, die aperture length and punch fillet radius on limiting drawing ratio (LDR), drawing load and thickness strain of the cup have been investigated. A die with half cone angle of 18° has shown the best drawability for the new technique. Finite element model results showed good agreement with experimental results. A die with an aspect ratio of 2 has been used with punches having aspect ratios ranging from 2 to 2.25. Tensile tests were carried out to obtain the stress-strain behavior for the used material. A total of seven punches were used for forming sheet metal of brass (CuZn33) with initial thicknesses of 1.5, 1.9, 2.4 and 3.2 mm at different clearance ratios (c/t). The effects of blank thickness and clearance ratio on limiting drawing ratio, drawing load and thickness strain were experimentally investigated. An elliptic cup with a limiting drawing ratio (LDR) of 2.26 has been successfully achieved.
16
Marco Schwarze, Ivaylo N. Vladimirov, Stefanie Reese · Computer Methods in Applied Mechanics and Engineering · 2010 · 60 citations
Aitor Arriaga, J.M. Lazkano, Rikardo Pagaldai et al. · Polymer Testing · 2006 · 46 citations
Natural Sciences, Materials Engineering, Materials Science +14