Biomechanical Analysis of Cervical Disc Replacement and Fusion Using Single Level, Two Level, and Hybrid Constructs

Abstract

In Brief Study Design. A biomechanical study comparing arthroplasty with fusion using human cadaveric C2–T1 spines. Objective. To compare the kinematics of the cervical spine after arthroplasty and fusion using single level, 2 level and hybrid constructs. Summary of Background Data. Previous studies have shown that spinal levels adjacent to a fusion experience increased motion and higher stress which may lead to adjacent segment disc degeneration. Cervical arthroplasty achieves similar decompression but preserves the motion at the operated level, potentially decreasing the occurrence of adjacent segment disc degeneration. Methods. 11 specimens (C2–T1) were divided into 2 groups (BRYAN and PRESTIGE LP). The specimens were tested in the following order; intact, single level total disc replacement (TDR) at C5–C6, 2-level TDR at C5–C6–C7, fusion at C5–C6 and TDR at C6–C7 (Hybrid construct), and lastly a 2-level fusion. The intact specimens were tested up to a moment of 2.0 Nm. After each surgical intervention, the specimens were loaded until the primary motion (C2–T1) matched the motion of the respective intact state (hybrid control). Results. An arthroplasty preserved motion at the implanted level and maintained normal motion at the nonoperative levels. Arthrodesis resulted in a significant decrease in motion at the fused level and an increase in motion at the unfused levels. In the hybrid construct, the TDR adjacent to fusion preserved motion at the arthroplasty level, thereby reducing the demand on the other levels. Conclusion. Cervical disc arthroplasty with both the BRYAN and PRESTIGE LP discs not only preserved the motion at the operated level, but also maintained the normal motion at the adjacent levels. Under simulated physiologic loading, the motion patterns of the spine with the BRYAN or PRESTIGE LP disc were very similar and were closer than fusion to the intact motion pattern. An adjacent segment disc replacement is biomechanically favorable to a fusion in the presence of a pre-existing fusion. Level of Evidence: N/A A biomechanical ROM study of 11 C2–T1 spines was performed on intact, 1-level total disc replacement (TDR), 2-level TDR, fusion + TDR, and 2-level fusion modes. The intersegmental motion patterns with a BRYAN or PRESTIGE LP disc were similar to the intact condition. With pre-existing fusion, adjacent segment TDR is biomechanically favorable compared with another fusion.