2013 · 11 citations · 6 references
Natural SciencesMaterials EngineeringMaterials ScienceBuilding MaterialsPolymer EngineeringPolymer MaterialsComposite MaterialsNanocompositesPolymer CompositesPolymer NanocompositesRecycled MaterialsWood MaterialsComposite Mechanical PropertiesFlexural StrengthMechanical Properties Of NanocompositesMechanical StrengthNanocomposite PolymersPolystyreneWood CompositesWood Polymer Composites
Mechanical properties of wood plastic composites made from wood flour, recycled polystyrene and Nanoclay have been investigated in this study. The wood flour was mixed with the recycled polystyrene at three weight ratios of 40, 50 and 60% for the experiments, while the nanoclay was used in 0, 3 and 5 Phc. Meanwhile, the coupling agent was used in all composite samples for 3 wt%. Wood plastic samples were prepared using injection molding then mechanical properties were evaluated including tensile and bending Tests. The obtained results indicated that the tensile strength and flexural strength were increased by raising nanoclay content in the composites. In order to produce wood polymer composites, natural fibers are added to thermoplastic polymers. During the last decade, wood plastic composites (WPC) have gained extensive applications in construction materials and automobile parts. The natural fibers which are used to reinforce the thermoplastics are basically comprised of wood, cotton, cotton fibers, hemp (cannabis fiber), jute (Indian cotton), sisal fiber and cane fibers. Advantages of using these fibers in composites are their light weight, high quality, low cost, annual renewability, good mechanical properties, reduced energy consumption and environmental friendliness (Ziaei et al., 2012). Polymer-clay nanocomposites have attracted much attention due to their improved mechanical, thermal and flammability properties. A great deal of experiments which have been done recently in laboratory have shown that the polymer-clay nanocomposites provide decreased flammability and improved mechanical properties at a rather small cost. Many types of polymeric resins have been used to artificially build polymer-clay nanocomposites. (Alexander et al., 2002) In fact, nanoclays improve properties of the polymeric composites due to their special dimensions and great apparent coefficient in comparison with other fillers (Tjong 2006). Wood plastic composites are probably one of the most dynamic segments of today's plastic industry. Although this technology is not that much new, there is a growing tendency to design new possibilities by integration of these materials. Polystyrene (PS) is the third most used thermoplastic in the world after polyethylene (PE) and polypropylene (PP. Introduction of wood fibers is a method used to enhance impact strength of this material due to some of the potential advantages it has. Therefore, this technique is known as an appropriate candidate for the polymeric composites armed by fibers (Justo et al., 2007). Fu and Naguib (2006) in their research on the effect of nanoclay filler on mechanical properties of composites declared that only 0.5% of montmorillonite can significantly increase elasticity modulus, tensile strength, flexural strength and elongation at break for the composite. They however argued that an excessive addition of the nanoparticles could reduce their mechanical strength with the optimal value of addition being 4-5%. Deshmane et al., (2007) in studied morphological and mechanical properties of polypropylene reinforced with nanoclay filler. They stated that this filler treatment would enhance mechanical strength due to formation of strong connection with polymer matrix. Han et al. (2008) examined the effect of using nanoclay and coupling agent on mechanical and thermal properties of composites obtained from bamboo fibers-heavy polyethylene. Their examinations revealed that flexural elasticity modulus, dynamic elasticity modulus and crystallinity degree were increased upon addition of 1% nanoclay, though impact strength of the samples was decreased. X-ray diffraction (XRD) data confirmed this observation as well since exfoliation structure is created in the composite. They also declared that all the mechanical properties were improved by addition of the coupling agent due to the increased interface area between polymer matrix and filler phase. METHODOLOGY
6