Shear Strength of Stud Connectors in Lightweight and Normal-Weight Concrete

Jorgen G. Ollgaard, R. G. Slutter, John W. Fisher

Engineering Journal · 1971 · 858 citations · 5 references

DOIFull text

Open access

Concepts

TL;DR

Steel‑concrete composite construction has been used since the 1920s, expanding from bridge work in the 1950s to widespread building applications after simplified design provisions were introduced in the 1961 AISC Specification, based on studies by Slutter and Driscoll. The main purpose of the investigation was to evaluate the capacity and behavior of stud shear connectors embedded in lightweight concrete. The study tested 48 two‑slab push‑out specimens using two normal‑weight aggregate types and three lightweight aggregate types, with lightweight concretes produced from coarse aggregate with natural sand and from lightweight fines.

Abstract

Steel-concrete composite construction using normal weight concrete has been used since early in the 1920s. Substantial use of composite construction began mainly for bridge structures in the 1950s as a result of the work done by Viest. Its primary growth in building construction during the last decade was a result of the simplified design provisions introduced into the 1961 AISC Specification. The development of these provisions were based on studies reported by Slutter and Driscoll. This study summarizes the results of tests on 48 two-slab pushout specimens. The main purpose of the investigation was to evaluate the capacity and behavior of stud shear connectors embedded in lightweight concrete. Two different types of normal-weight aggregates and three types of lightweight aggregate were examined. The lightweight concretes were made with both lightweight coarse aggregate with natural sand and with lightweight fines.

References

5