Influence of heat input and travel speed on microstructure and mechanical properties of double tandem submerged arc high strength low alloy steel weldments

David M. Viano, Naseem Ahmed, G.O. Schumann

Science and Technology of Welding & Joining · 2000 · 84 citations · 7 references

Concepts

TL;DR

The study evaluates microstructural characteristics and mechanical properties of 20 mm thick Australian HSLA 80 steel welds. Nine butt joints were fabricated by double‑tandem four‑wire submerged arc welding with varied heat input and travel speed, and colour‑etching revealed solidification structures that correlated with these parameters. Increasing heat input slows cooling, enlarges cellular dendritic spacing, reduces acicular ferrite content, and coarsens ferrite laths, while travel‑speed effects on delta ferrite spacing and grain size depend on heat input, and higher travel speed and current density raise deposition rates without compromising joint quality.

Abstract

An evaluation is presented of the microstructural characteristics and mechanical properties of welds in 20 mm thickness high strength low alloy steel HSLA 80, of Australian manufacture. In total, nine butt joints were prepared using the double tandem (four wire) submerged arc welding process in which both heat input and travel speed were varied. The inclusion size distribution was determined for selected welds and showed that heat input had a major effect. Colour etching techniques were used to reveal the solidification structure, which in turn correlated with welding parameters. As the heat input increased, the cooling rate decreased resulting in a larger cellular dendritic cell spacing, decreased acicular ferrite content, and coarser acicular ferrite laths. The effect of travel speed on delta ferrite cell spacing and prior austenite grain size was found to be co-dependent on the heat input and the thermal profile resulting from multiple electrode welding. These results show that increased deposition rates can be achieved by increasing the travel speed and current density without sacrificing joint quality.

References

7