IEEE Transactions on Dielectrics and Electrical Insulation · 2004 · 22 citations · 10 references
Natural SciencesMaterials SciencePhysicsCeramic MaterialsMaterials CharacterizationMaterials PhysicsConductive MaterialsDielectric CeramicsDielectric MaterialsElectrical Properties Of CeramicsFerroelectric MaterialsIonic ConductivityBarium TitanateCeramic DielectricsComposite DielectricsConductivityConductivity In Composite MaterialsFerroelectricityPermittivityPolarization
Dielectric and conductive frequency spectra in a 10 mHz-10 GHz range have been measured for a composite consisting of barium titanate (BaTiO/sub 3/) inclusions dispersed in a LiClO/sub 4/-doped polyethylene oxide (Li-PEO) matrix with volume fraction /spl Phi/ = 0-40%. Pure Li-PEO behaves as a dielectric showing a segmental-mode dielectric relaxation at high frequencies (dielectric regime) and transfers to an ionic conductor below 10 MHz (conductive regime). BaTiO/sub 3/ is a ferroelectric having a very large dielectric permittivity and spontaneous polarization. The introduction of BaTiO/sub 3/ into Li-PEO caused a rapid increase in permittivity in the dielectric regime. In the conductive regime, the composite exhibited an additional relaxation at a frequency related to the ratio of DC conductivity of Li-PEO and the permittivity of BaTiO/sub 3/. This relaxation was attributed to accumulation of dissociated Li/sup +/ and ClO4/sup o/ns at the inclusion/matrix interface which resulted in an increase of effective permittivity and a decrease of effective conductivity. Quantitative analyses based on mixing laws for the two-phase spherical dispersion system have shown that the Bruggeman equation accurately predicted the /spl Phi/-dependence of the effective permittivity over the entire frequency range. Regarding the effective conductivity, it predicted values lower than the observed. We attributed this discrepancy to the spontaneous polarization of BaTiO/sub 3/, which induced ion trapping to reduce the DC conductivity of Li-PEO matrix.
10