2001 · 22 citations · 9 references
EngineeringAerospace EngineeringMechanical EngineeringAerodynamicsAerospace StructuresAircraft DesignAerodynamic DesignStructural OptimizationWeight EstimationWing DesignWing StructuresWing TheoryDragFuel Weight EstimationGross Weight EstimationInduced DragLift CoefficientLift DistributionWing Structural OptimizationWing Weight Reduction
The classic minimum induced drag spanload is not necessarily the best choice for an aircraft. Here, a discrete vortex method which finds the minimum induced drag in the Trefftz plane has been used to calculate optimum spanloads for non-coplanar multisurface configurations. The method includes constraints for lift coefficient, pitching moment coefficient and wing root bending moment. The wing root bending moment constraint has been introduced so that by holding wing geometry fixed, changes in wing weight can be related to variations in spanload distributions. Changes in wing induced drag and weight were converted to aircraft total gross weight and fuel weight benefits, so that the spanloads that give maximum take-off gross weight reduction can be found. Results show that a reduction in root bending moment from a lift distribution that gives minimum induced drag leads to more triangular spanloads, where the loads are shifted towards the root, reducing wing weight and increasing induced drag. A slight reduction in root bending moment is always beneficial, since the initial increase in induced drag is very small compared to the decrease in wing weight. Total weight benefits were studied for a B-777 type configuration, obtaining take-off gross weight improvements of about 1% for maximum range missions. When performing reduced-range missions, improvements can almost double. A long range, more aerodynamically driven aircraft like the B-777 will experience lower benefits as a result of increasing drag. Short to medium range aircraft will profit the most from more triangular lift distributions.
9