Anionic heterogeneous polymerization of methacrylonitrile by <i>n</i>‐butyllithium

Abstract

Abstract The anionic heterogeneous polymerization of methacrylonitrile by butyllithium in petroleum ether was investigated. The polymerization was of the “living” type, as seen from the linear dependence of the molecular weights on [MAN]/[BuLi]. This behavior was further supported by block polymerization experiments in which the monomer was added in two portions and the molecular weights obtained were directly proportional to the total monomer concentration. The initiator efficiency was low, and initiator consumption was only about 2%. This fact, together with the results of the block polymerizations showed that there was preferential addition of monomer to the growing chain ends rather than to the initiator. The molecular weights were independent of the rate of monomer addition. This as well as the “living” behavior of the polymerization of methacrylonitrile on a wide range of monomer and catalyst concentrations and the absence of chain transfer to monomer was essentially different from that of the similar heterogeneous polymerization of acrylonitrile by butyllithium previously investigated. This is due to the absence of an α‐acidic hydrogen in methacrylonitrile.