In-Shoe Pressure Distribution for Running in Various Types of Footwear

Ewald M. Hennig, Thomas L. Milani

Journal of Applied Biomechanics · 1995 · 120 citations · 10 references

Concepts

TL;DR

Discrete pressure sensors measured foot forces at eight sites in 22 subjects wearing 19 running‑shoe models while mechanical sole properties were assessed with an impacter and ground‑reaction, pressure, and acceleration data were recorded at 3.3 m/s. The study found that rear‑foot lateral loading precedes medial forefoot loading, with push‑off forces concentrated on the first metatarsal head and hallux, and that shoe construction markedly alters plantar pressure patterns, while the selected sensor sites reliably estimate vertical ground‑reaction force.

Abstract

Discrete pressure sensors were used to examine the influence of shoe construction on the local forces under the foot. Measurements were performed at eight locations under the feet of 22 subjects wearing 19 different models of running shoes. Mechanical properties of shoe soles were assessed with an impacter device. Pressure distribution, ground reaction force, and acceleration data were collected simultaneously during running at 3.3 m/s. Early lateral loading of the rearfoot was followed by increasing medial forefoot loads. In the later phase of pushoff the load was almost entirely carried by the first metatarsal head and the hallux. Substantial differences in plantar foot pressures and relative loads among shoe models indicated that footwear construction has a substantial influence on the loading behavior of the foot during ground contact. Finally, the chosen sensor locations under the foot were found to be adequate to estimate the vertical ground reaction force.

References

10