Drained strength of bentonite-enhanced sand

L. H. Mollins, Douglas I. Stewart, T. W. Cousens

Géotechnique · 1999 · 37 citations · 8 references

Concepts

Abstract

INTRODUCTION
\n
\nBarriers with a low hydraulic conductivity are used
\nas part of waste containment systems to prevent
\ngroundwater contamination by liquids from the
\nwaste. Commonly barriers are either a geomembrane
\n(usually an HDPE sheet), a mineral layer or
\na combination of the two. Recently there has been
\nincreasing interest in the use of bentonite±sand
\nmixtures as the mineral layer, in both land®ll liners
\nand vertical cut-off walls, partly because they are
\nless susceptible to frost damage and desiccation
\ncracking than compacted clay (Dixon et al., 1985;
\nKraus et al., 1997). Currently there is uncertainty
\nabout the strength and bearing capacity of these
\nmaterials. This note reports drained strength data
\nfor bentonite±sand mixtures and proposes that
\ntrends in these data are mainly the result of variations
\nin the relative density of the sand.

References

8