2011 · 25 citations · 1 references
EngineeringManufacturing EngineeringMaterials EngineeringMaterials ProcessingMechanical Behavior Of MaterialsThermal AnalysisAsh Content AnalysisTimber MaterialsWood MaterialsWood ProductsWoodworking TechnologyAsh BehaviorAsh CharacterizationAsh ContentSawingWoodworking Materials
This paper presents the results of granulometric analyses of sawdust of unmodified and thermally- modified ash wood (Fraxinus exelsior L.) sawed on a narrow-kerf sash gang saw. The sawdust of dry thermally-modified ash produced in the sawing process on a frame sawing machine PRW15-M at a feed speed in the range of 0.36-1.67 m·min -1 has chip granularity ranging from 33.5 µm to 9.9 mm; whereas unmodified ash wood sawdust consists of chips in a granularity range from 35.6 µm to 13.8 mm. It was observed that thermally-modified ash sawdust is finer, with a distinctly larger share of the fraction in the granularity range a = 125-500 μm and a slightly increased share of the fraction in the range a = 32-125 μm. Changes in mechanical characteristics of modified wood were also observed in the technologi cal usefulness of a part of dry sawdust chip in the granularity range a = 250 μm-2.4 mm. While the homogenous share of chips in sawdust produced in the process of sawing of dry ash wood was HSCh a = 81-84 %, the demonstrated homogenous share of chips in ash sawdust formed in the process of sawing of dry thermally-modified wood was lower by 4-6 %.
1