SAE international journal of fuels and lubricants · 2009 · 15 citations · 20 references
EngineeringChemical EngineeringPetroleum EngineeringCombustionInternal Combustion EnginesAsh Content AnalysisCombustion AnalysisCombustion In EnginesCombustion ProcessesDiesel TechnologyEngine EmissionsAsh Content QuantificationCombustion Emissions AssessmentHigh-temperature Oxidation AnalysisHigh-temperature Oxidation ProductsHydrocarbon Emissions MeasurementOil ConsumptionOil Consumption Measurement
<div class="htmlview paragraph">Diesel engine ash emissions are composed of the non-combustible portions of diesel particulate matter derived mainly from lube oil, and over time can degrade diesel particulate filter performance. This paper presents results from a high temperature oxidation method (HTOM) used to estimate ash emissions, and engine oil consumption in real-time. Atomized lubrication oil and diesel engine exhaust were used to evaluate the HTOM performance.</div> <div class="htmlview paragraph">Atomized fresh and used lube oil experiments showed that the HTOM reached stable particle size distributions and concentrations at temperatures above 700°C. The HTOM produced very similar number and volume weighted particle size distributions for both types of lube oils. The particle number size distribution was unimodal, with a geometric mean diameter of about 23 nm. The volume size distribution had a geometric volume mean diameter of about 65 nm.</div> <div class="htmlview paragraph">Inductively coupled mass spectrometry (ICP-MS) was used to determine the ash content of different lube oils, revealing the differences in elemental compositions of ash for a fresh lube oil and an used lube oil; the most notable changes were a 166% increase in Mg and a 194% increase in Fe concentrations. The mass penetration fraction of lube oil using the HTOM was compared to the oil ash concentrations found from the ICP-MS analysis and the results are discussed.</div> <div class="htmlview paragraph">The HTOM was also used to measure exhaust ash concentrations from a passenger car Diesel engine during steady-state and transient engine conditions. Using known oil ash compositions the HTOM was used to estimate engine oil consumption rates from exhaust ash measurements.</div>
20
David B. Kittelson · Journal of Aerosol Science · 1998 · 2.3K citations
Emissions of fuel metals content from a diesel vehicle engine
Ya‐Fen Wang, Kuo‐Lin Huang, Chun‐Teh Li et al. · Atmospheric Environment · 2003 · 276 citations
Engineering, Automotive Engineering, Chemical Engineering +14
Stephen M. Toner, David A. Sodeman, Kimberly A. Prather · Environmental Science & Technology · 2006 · 164 citations