Rapid Communications in Mass Spectrometry · 2000 · 31 citations · 4 references
Natural SciencesChemical EngineeringPetroleum EngineeringCorrosion ScienceMarine CorrosionOffshore Petroleum EngineeringCorrosion InhibitorsMarine Pollutant ChemistrySediment-water Interface ChemistryAqueous-phase ChemistryCorrosion In Marine EnvironmentsCorrosion Inhibitor TestingMarine Corrosion InhibitionOil-water PartitioningOil-water SeparationProduced Water CharacterizationTandem Mass Spectrometry Analysis
During oil production, significant quantities of water are produced with the crude oil which, following treatment on the platform, are discharged to the marine environment. This produced water contains residues of oilfield chemicals added by the platform operators to the topside processing equipment to aid oil-water separation and mitigate operational problems. The levels of oilfield chemicals entering the marine environment via this route were investigated using electrospray ionisation tandem mass spectrometry (ESI-MS/MS) and wet chemical analysis techniques. The generic nature of different chemical types was shown by ESI-MS/MS. Studies of the partitioning behaviour of corrosion inhibitors and demulsifiers between the oil and water phases of the produced fluids suggested corrosion inhibitors partitioned primarily into the aqueous phase and demulsifiers into the oil phase. This was reflected in levels observed in produced water although, in the case of a corrosion inhibitor, lower than expected concentrations were measured. Scale inhibitors were discharged with the produced water at their dosing concentrations. Marine sediments in the proximity of two North Sea oil platforms contained low levels of benzalkonium quaternary ammonium salts (0.74-10.84 ng/g), typical corrosion inhibitor chemicals.
4