Journal of Propulsion and Power · 2010 · 75 citations · 26 references
EngineeringMaterials EngineeringMaterials ScienceCeramicsCombustionMaterials ChemistryCombustion FundamentalsCombustion KineticsCombustion ProcessesCombustion StoichiometryFuel CharacteristicsFuel ChemistryCombustion ChemistryCombustion Pressure EffectsConstant-volume CombustionOptimal Mixture RatiosOxidizer-fuel RatioPellet PressingPressure DependencePressure Exponent Behavior
DOI: 10.2514/1.46182 The combustion of Si- and Al-based systems using polytetrafluoroethylene (PTFE) as the oxidizer and Fluorel FC 2175 (a copolymer of hexafluoropropylene and vinylidene fluoride) as a binder has been studied. Experimental data were obtained using two methods: 1) instrumented tube burns and 2) pressed pellets inside a windowed pressure vessel. Loose-powder burning rates were seen to optimize at slightly-fuel-rich mixture ratios for Si/PTFE/FC-2175 (SiTV). Al/PTFE/FC-2175 (AlTV) burning rates optimized near a stoichiometric ratio. Pressures calculated by assuming constant-volume combustion equilibrium were seen to match experimental values from burn-tube experiments when burning rates were at or near peak values. The pressure dependence of SiTV and AlTV pellet burning rates was also characterized and compared with reported Mg/PTFE/Viton (MTV) results. SiTV showed power-law dependence with a constant-pressure exponent over the experimental range of pressures. AlTV was showntoexhibitnonconstant-pressureexponentbehavior.SiTVburningratesoptimizedatmixtureratiossimilarto that of the tube burns. AlTV burning rates increased well past a stoichiometric ratio and decreased at a fuel-rich ratio, which is a similar trend to MTV burning rates.
26
Handbook of Chemistry and Physics.
Alfred Burger · Journal of Medicinal Chemistry · 1965 · 3.7K citations
J. Buckmaster, G. S. S. Ludford, Howard W. Emmons · Journal of Applied Mechanics · 1983 · 503 citations · Full text
Engineering, Chemical Engineering, Mechanical Engineering +17