Journal of Polymer Science · 1961 · 18 citations · 1 references
Natural SciencesChemical EngineeringChemistryCatalysisChemical KineticsPolymer ChemistryCatalytic Reaction KineticsPolymer SynthesisPolymerization ChemistryPolymerization KineticsPolymerization ProcessesPolymerization Temperature EffectsCatalyst KineticsFormaldehydeInitial Rate AnalysisPolymerization CatalysisPolymerization MechanismsPolymerization ReactionsViscosity Effects On Polymerization
Abstract Polymerization of formaldehyde was studied in diethyl ether solution at −58°C. Monomeric formaldehyde has been prepared through pyrolysis of carefully dried paraformaldehyde and purified by passage through liquid formaldehyde at its boiling point and subsequent condensation in a reservoir. A catalytic system consisting of n ‐dibutylamine has been used. The course of polymerization was studied in a dilatometer provided with a stainless steel stirrer, since the polymer formed is insoluble in the reaction mixture. The components (i.e., liquid monomer, solvent, and catalyst solution) were measured into the dilatometer under dry nitrogen so as to form separate layers, one on top of the other. The polymerization reaction was started by mixing the contents. The rates of reaction were chosen so that the initial overall rate of reaction did not exceed 5% conversion per min. It was observed that at constant n ‐dibutylamine concentration the overall rate of reaction increases with increasing water concentration, while the molecular weight as checked by viscometry practically did not change. The n ‐dibutylamine‐water ratio lay in the range from 1:10 to 1:1000 at a formaldehyde concentration of 5 mole/l. With increasing n ‐dibutylamine concentration (in the range from 2.5 to 14 μmole/l.) and at a constant concentration of water (3.5 mole/l.) the overall rate of reaction increases while the molecular weight does not change. The results obtained permit a study of dissociation equilibria of amines with water in nonaqueous media. The role played by water in the formation of the anion ‐OH (which initiates the polymerization) and the influence of the structure of the cation R x NH y + on molecular termination or possibly transfer are discussed.
1