Polymer-Plastics Technology and Engineering · 2010 · 96 citations · 13 references
EngineeringMaterials EngineeringMaterials ScienceJoiningMechanical Behavior Of MaterialsPolymer MaterialsFriction Stir WeldingWeldingWelding ProcessesFriction Stir ProcessingFriction Stir Welding ProcessTemperature OptimumTensile StrengthThermomechanical EffectsWeld TestingWelded JointsWelding Speed
The aim of this study was to investigate the weldability of UHMW-polyethylene via friction stir welding method. The samples were joined with single pass under 960–1960 rpm rotational speeds and 10–20 mm/min transverse speeds. In this study, three different heating processes were used. These processes are welding at room temperature, welding by pre-heating from the bottom of plastic samples at 50°C and 80°C with metal molding. A tensile test, durometer hardness test and an optical microstructure analysis were conducted on welded joint. In the experiments, a tensile strength of 72% was achieved in non-preheated welds whereas tensile strength of parent material was achieved approximately at an optimum value of 89% by pre-heating at 50°C. Pre-heating process enabled a homogeneous heat distribution by approximating the plastic material to fusing point in a short time and facilitated mixing and as a result welded joint of a supremer characteristic was obtained.
13