IEEE Microwave and Wireless Components Letters · 2011 · 15 citations · 8 references
EngineeringElectrical EngineeringAntennasMicroelectromechanical SystemsMicrowave EngineeringImpedance MatchingImpedance Matching CircuitsMicrowave Integrated CircuitsMicrowave Network AnalysisTransducer TechnologyWaveguidesCharacteristic ImpedanceCutoff FrequencyIsolationNumerical SimulationRidge WaveguidesTransducer DesignWaveguide JunctionsWaveguide Simulation
We present a compact L-band orthomode transducer (OMT) with a new waveguide junction consisting of a quad-ridged square waveguide and four single-ridged triangular waveguides. Quad-ridged square and single-ridged triangular waveguides of various sizes were numerically analyzed to estimate the cutoff frequencies and characteristic impedances of the waveguides. An optimum junction structure for the OMT with a low cutoff frequency and specific characteristic impedance was found based on the numerical simulation. The junction has a relatively small size without waveguide branches, and provides good impedance matching with a 50 Ω coaxial feed line. In addition, Klopfenstein and linear tapers were employed to design waveguide ridges for minimizing mismatches at the OMT junction. Measurement showed a bandwidth of about 400 MHz from 1.0 to 1.4 GHz and an isolation level below -40 dB in the frequency range. The cross section of the OMT was reduced to 62% of the standard waveguide cross section, and the total length is only 56 cm (2.24 λ <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">0</sub> ) at 1.2 GHz.
8
A Transmission Line Taper of Improved Design
R. W. Klopfenstein · Proceedings of the IRE · 1956 · 465 citations
Madhavan Swaminathan, Ercüment Arvas, Tapan K. Sarkar et al. · IEEE Transactions on Microwave Theory and Techniques · 1990 · 87 citations
Engineering, Electrical Engineering, Computational Electromagnetics +16