Capillary and slit‐die flow of two liquid‐crystalline polymers. The effect of pressure on viscosity

Abstract

Abstract Viscosity measurements on two commercial thermotropic liquid crystalline polymers (LCPs) (a copolyester and a polyesteramide) were performed using both capillary and slit die methods. The results are in agreement with those presented in the literature for the same LCPs, when the measurements are carried out with a L/D = 30 die; these results are affected more by Bagley corrections for the polyesteramide than for the copolyester. For both LCPs, viscosities measured in the slit die are lower than those obtained by capillary rheometry. Nevertheless, the difference is much bigger in the case of the polyesteramide, for which a reduction by a factor of 3 is observed. This is not due to the preshear or thermal history, since the same piston‐barrel system and thermal treatment were applied in both types of measurements. Depending on the polymer sample and temperature, concave and convex curvatures were observed in the pressure profiles during the slit flow. From these curvatures, the pressure coefficient α of viscosity was evaluated. However, in the case of the polyesteramide the convex curvature leads to a negative coefficient (the viscosity decreases with pressure, instead of increasing). This result may be explained by envisaging a change in the structure of the melt along the slit length. © 1993 John Wiley & Sons, Inc.