Proceedings of the National Academy of Sciences · 2015 · 226 citations · 42 references
Natural SciencesMaterials EngineeringMaterials ScienceElectronic MaterialsEnergy MaterialsMaterials ThermodynamicsEnergy ConversionThermoelectric MaterialsPower Conversion EfficiencyPower FactorPower GenerationPower OutputThermoelectric Energy ConversionThermoelectric Figure Of MeritThermoelectric PropertiesWaste Heat Utilization
Thermoelectric power generation is a promising way to convert waste heat and solar energy, yet research has traditionally focused solely on maximizing the figure‑of‑merit ZT. This study argues that a high power factor is equally essential for high‑power generation, alongside efficiency. The authors introduce the n‑type alloy Mg₂Sn₀.₇₅Ge₀.₂₅, which simultaneously achieves high ZT and high PF. Mg₂Sn₀.₇₅Ge₀.₂₅ exhibits an average ZT of 0.9 and PF of 52 μW cm⁻¹ K⁻² between 25–450 °C, peaks at ZT 1.4 (450 °C) and PF 55 μW cm⁻¹ K⁻² (350 °C), and delivers a calculated leg efficiency of 10.5 % and output power of 6.6 W cm⁻² under a 150 °C mm⁻¹ gradient (400 °C/50 °C).
Thermoelectric power generation is one of the most promising techniques to use the huge amount of waste heat and solar energy. Traditionally, high thermoelectric figure-of-merit, ZT, has been the only parameter pursued for high conversion efficiency. Here, we emphasize that a high power factor (PF) is equivalently important for high power generation, in addition to high efficiency. A new n-type Mg2Sn-based material, Mg2Sn0.75Ge0.25, is a good example to meet the dual requirements in efficiency and output power. It was found that Mg2Sn0.75Ge0.25 has an average ZT of 0.9 and PF of 52 μW⋅cm(-1)⋅K(-2) over the temperature range of 25-450 °C, a peak ZT of 1.4 at 450 °C, and peak PF of 55 μW⋅cm(-1)⋅K(-2) at 350 °C. By using the energy balance of one-dimensional heat flow equation, leg efficiency and output power were calculated with Th = 400 °C and Tc = 50 °C to be of 10.5% and 6.6 W⋅cm(-2) under a temperature gradient of 150 °C⋅mm(-1), respectively.
42
Complex thermoelectric materials
G. Jeffrey Snyder, Eric S. Toberer · Nature Materials · 2008 · 11.1K citations
High-Thermoelectric Performance of Nanostructured Bismuth Antimony Telluride Bulk Alloys
Bed Poudel, Qing Hao, Yi Ma et al. · Science · 2008 · 5.5K citations
Natural Sciences, Materials Engineering, Materials Science +16
Ultralow thermal conductivity and high thermoelectric figure of merit in SnSe crystals
Li‐Dong Zhao, Shih‐Han Lo, Yongsheng Zhang et al. · Nature · 2014 · 5.1K citations
Convergence of electronic bands for high performance bulk thermoelectrics
Yanzhong Pei, Xiaoya Shi, Aaron D. LaLonde et al. · Nature · 2011 · 4.2K citations