Development of oxides at TBC – bond coat interfaces in burner rig exposures

Abstract

There is a desire to use gases derived from increasingly ‘dirty’ fuels (e.g. coal and biomass) in industrial gas turbines. The contaminants in these fuels have the potential to cause significant damage to the gas turbine hot gas path materials, many of which were developed and selected for natural gas fired conditions. This paper reports results of a study investigating the performance of thermal barrier coatings (TBCs) and bond coatings, applied to current industrial gas turbine materials, within clean and ‘dirty’ gas environments generated within a burner rig.The materials covered by this study included: • TBCs based on 8%Y2O3–ZrO2 applied by both air plasma sprayed (APS) and electron beam – physical vapour deposition (EB–PVD) routes.• Bond coats of the overlay and diffusion classes, applied by vacuum plasma spraying (VPS), electroplating (EP), chemical vapour deposition (CVD) and high velocity oxy-fuel (HVOF) spraying• Base alloys of IN6203, CMSX-4 and Haynes 230The required TBC/bond coat combinations were applied by commercial coating processes to cylindrical samples of base alloys manufactured for use in a burner rig.The burner rig used in this study is designed to enable air-cooled probes of cylindrical samples to be exposed to a natural gas combustion environment. In this study, this enabled specific metal temperatures (~800 and ~900°C) to be targeted within a much higher temperature combustion gas stream (~1150°C). ‘Dirty’ fuel gas environments were simulated by introducing gaseous (SO2 and HCl) and vapour phase (Na, K, Pb, Zn) contaminants into the burner rig just upstream of the edge of the gas flame. These conditions enabled continuous tests to be performed for 1,000 hours in both natural gas and ‘dirty’ fuel environments.The relative performance of the materials was determined from cross-sections prepared after the 1000 hour exposures. These cross-sections were examined by optical and SEM/EDX to determine the thicknesses of the oxides at the TBC – bond coat interfaces, the morphologies of these interfaces and to characterise the elemental distributions in these regions.