2007 · 12 citations · 12 references
EngineeringMaterials ScienceMechanical EngineeringMechanical Behavior Of MaterialsStructural MaterialsTribologyGear TribologyLubricant PropertiesLubrication EngineeringLubrication SystemsTribological MaterialsWear-resistant MaterialsFailure ModesGear LubricationGear WearGearsSpur GearsSurface Wear DepthWearWear Analysis
Gear contact surface wear is one of the important failure modes for gear systems. Dedicated experiments are required to enable precise evaluations of gear wear for a particular application. The application of interest for this study required evaluation of wear of gears lubricated with a grade 2 perfluorinated polyether grease and having a dithering (rotation reversal) motion. Experiments were conducted using spur gears made from AISI 9310 steel. Wear was measured using a profilometer at test intervals encompassing 10,000 to 80,000 cycles of dithering motion. The test load level was 1.1 GPa maximum Hertz contact stress at the pitch-line. The trend of total wear as a function of test cycles was linear, and the wear depth rate was approximately 1.2 nm maximum wear depth per gear dithering cycle. The observed wear rate was about 600 times greater than the wear rate for the same gears operated at high speed and lubricated with oil.
12
Contact and Rubbing of Flat Surfaces
J. F. Archard · Journal of Applied Physics · 1953 · 7.7K citations
Statistical Intervals: A Guide for Practitioners
Jason R. Jones, Gerald J. Hahn, William Q. Meeker · Technometrics · 1993 · 534 citations
Simulation of mild wear in spur gears
Anders Flodin, Sören Andersson · Wear · 1997 · 287 citations
Engineering, Mechanical Engineering, Mechatronics Engineering +14
Simulation of mild wear in helical gears
Anders Flodin, Sören Andersson · Wear · 2000 · 152 citations
Engineering, Mechanical Engineering, Mechatronics Engineering +14