Dynamic Properties of Offshore Silty Samples

Kenneth H. Stokoe, William M. Isenhower, Jrc Hsu

Offshore Technology Conference · 1980 · 38 citations · 0 references

Concepts

Abstract

ABSTRACT Shear moduli and material damping of six intact soil samples were investigated. The samples ranged from clayey silts (ML) to silty clays (CL and CH). Moduli and damping were determined by both resonant column and torsional shear tests. The resonant column tests were performed at frequencies above 15 Hz while the torsional shear tests were performed at a frequency of 0.1 Hz. Testing was conducted over a range in shearing strains from 0.0003 to above 0.3 percent, over a range in confining pressures from 2.5 to 80 psi, and over a range in confinement times from two to ten days at each pressure. Shear modulus and material damping were essentially constant below a threshold shearing strain of about 0.001 percent. In this range modulus values determined by torsional shear tests were always slightly below modulus values determined by resonant column tests because of the effect of strain rate. On the other hand, torsional shear damping values in this low-strain range were always above those values determined in the resonant column test. Material damping decreased and shear modulus increased with time of confinement below the threshold shearing strain in both types of tests. Above the threshold shearing strain, shear modulus decreased and material damping increased as strain amplitude increased. At a shearing strain of 0.1 percent, shear moduli from torsional shear tests were above those values determined by resonant column tests, possibly because of cyclic degradation. However, the effect of number of load cycles on shear modulus was dependent upon soil type. For the silty clay, shear modulus decreased with number of cycles of loading above a shearing strain of about 0.01 percent. For the clayey silt, shear modulus increased slightly with number of load cycles above a strain amplitude of about 0.03 percent. Material damping also exhibited an apparent sensitivity to strain rate and number of load cycles as well as a sensitivity to the testing technique. INTRODUCTION An understanding of the behavior of foundation soils under cyclic loading is required in the dynamic analysis of offshore structures subjected to earthquake excitation or storm wave action. This behavior is commonly expressed in terms of shear modulus and material damping of the soil at prescribed numbers of cycles of loading. For onshore soils, shear modulus and material damping have been intensely studied over the past two decades and have been found to be functions of variables such as shearing strain amplitude, magnitude of confining pressure, number of cycles of loading, duration of confinement, and shearing strain rate (Hardin and Drnevich, 1972; Hardin, 1978; Woods, 1978). The effects of these variables on offshore soil samples composed of significant amounts of silt were studied. The samples were recovered from a site off the coast of Southern California and were tested with torsional she arresonant column devices. This testing is unique in that torsional shear (low-frequency shearing) and resonant column (high-frequency shearing) tests can be performed on the same soil specimen over a large range in shearing strains, confining pressures, confinement times, and strain rates.