Engineering · 2011 · 25 citations · 16 references
Natural SciencesMaterials EngineeringMaterials ScienceElectrochemical EngineeringElectrochemistryNanomaterialsElectrochemical CellsElectrode MaterialsThermoelectric MaterialsThin Film Electrical PropertiesThin-film DepositionThin-film MaterialsBismuth Film ElectrodesBismuth Telluride-based MaterialsCurrent DensityElectrochemical DepositionFilm ThicknessThermoelectric PropertiesThin Film ThermoelectricsThin-film Electrodes
Bismuth telluride thick films are suitable for thermoelectric (TE) devices covering large areas and operating at small-to-moderate temperature differences (20 - 200 K). High efficiency and high coefficient of performance (COP) are expected to be achieved by using thick films in some cooling applications. Bismuth telluride thick films fabrication have been achieved with Galvanostatic and Potentionstatic deposition. Stoichiometric bismuth telluride thick film was obtained by Galvanostatic deposition at current density of 3.1 mAcm-2. Bismuth telluride films with average growth rate of 10 µmh-1 and different composition were obtained. Effects of current density and composition of electrolyte in Galvanostatic deposition were studied. The current density affected the film compactness, where films deposited at lower current density were more compact than those deposited at higher current density. The morphology of the films did not depend on the current density, but chemical composition was observed when different composition of electrolyte was used. Effects of distance between electrodes, composition of electrolyte solution, and stirring in Potentionstatic deposition were studied. The shorter the distance between electrodes, the higher the electric field, thus the higher current density was applied and the deposited film was less compact. The current density increased more rapidly with stirring during electrodeposition which leads to less compact film. Through this study, films electrode-posited from solution containing 0.013 M Bi(NO3)3.5 H2O, 0.01 M TeO2 and 1 M HNO3 at 3.1 mA cm-2 for 6 hours without stirring and with interelectrode distance of 4.5 cm were free-standing with average film thickness of 60 µm and optimum film composition of Bi2Te3. The crystallite size of the later films was found to be around 4.3 nm using Scherrer’s equation from XRD patterns. Also, negative Seebeck coefficient for the same samples was revealed with an average value of -82 μV.K-1.
16
New Directions for Low‐Dimensional Thermoelectric Materials
M. S. Dresselhaus, Gang Chen, Ming Tang et al. · Advanced Materials · 2007 · 4K citations
Materials Research Society Symposium Proceedings
A. Saiani, E. Vey, Anndrea Miller et al. · Research Explorer (The University of Manchester) · 2007 · 1.4K citations
Natural Sciences, Materials Engineering, Materials Science +10
Insights into the Electrodeposition of Bi[sub 2]Te[sub 3]
Marisol Martín‐González, Amy L. Prieto, R. Gronsky et al. · Journal of The Electrochemical Society · 2002 · 242 citations · Full text