Probabilistic Fatigue Analysis of Fixed Offshore Structures

J. H. Vughts, R.K. Kinra

Offshore Technology Conference · 1976 · 30 citations · 0 references

Concepts

Abstract

ABSTRACT This paper describes the application of probabilistic techniques to the detailed determination of local stress histories, thus permitting a detailed member-by-member fatigue analysis of fixed offshore structures. Using a suitable static or dynamic structural analysis program, the transfer functions for hot spot stresses at four points around each member end in the structure are generated as a function of wave frequency and direction. For each given sea state and wave direction, short-term stress statistics at the hot spots are calculated from the associated wave spectrum and transfer function. The resulting short-term stress statistics in all the yearly sea states in the wave scatter diagram, and for given probabilities of occurrence of the various wave directions, are then combined to yield long-term stress statistics at each hot spot. Finally, Miner1s cumulative damage law is applied to evaluate local fatigue damage. INTRODUCTION General Description of Fatigue in Offshore Structures Failure by fatigue in welded structures is related to the variable loads experienced by the structure during its life. Fatigue under random loading conditions, as experienced offshore, is a complex subject. In the present state of the art for welded steel structures, the following comments are generally accepted to be true [1,2, 3]:–welded connections are most susceptible to the development of fatigue cracks,–small sharp defects inevitably exist in welds and act as crack initiators,–as a result, fatigue in offshore structures is predominantly a matter of crack propagation,–in as-welded connections, stresses of yield strength magnitude in tension exist due to residual stresses,–stress fluctuations are, therefore, from tension yield downwards and the range of the fluctuation alone is the governing parameter,–consequently, in welded structures fully tensile stress cycles and partially or wholly compressive stress cycles are equally damaging,–the fatigue strength of welded connections is independent of the yield strength of currently used structural steels,–crack propagation and, consequently, fatigue damage in an offshore environment will continue at some rate no matter how small the stress range, i.e. there is no endurance limit as is found in constant amplitude cyclic loading above 2 × 106 cycles, and–shear stresses may be neglected in fatigue life calculations. Stress fluctuations normally occur predominantly as a result of wave loads. These wave induced stresses are of variable magnitude and occur in random order. The true time history of the local stresses is almost invariably simplified in that it is assumed to be adequately described in statistical terms by a reasonable number of stress blocks. Each stress block consists of a number of cycles of constant stress range. Thus the sequence of variations in the true stress history is lost. The cumulative effect of all the stress blocks representing the stress history is estimated by Miner's rule of linear accumulation of damage: (Equation available in full paper)