On the use of microjets to suppress turbulence in a Mach 0.9 axisymmetric jet

V.H. Arakeri, A. Krothapalli, V.K. Siddavaram, Mehmet Alkislar, Luiz Lourenco

Journal of Fluid Mechanics · 2003 · 279 citations · 0 references

Concepts

TL;DR

Microjets were operated at a mass flow rate of approximately 1 % of the primary jet mass flux. Microjets reduced near‑field turbulent intensities by about 15 % axially and 20 % normally, lowered peak turbulent shear stress by up to 40 %, diminished peak normalized vorticity in the shear layer, and cut the lateral near‑field sound pressure level by roughly 2 dB.

Abstract

We have experimentally studied the effect of microjets on the flow field of a Mach 0.9 round jet. Planar and three-dimensional velocity field measurements using particle image velocimetry show a significant reduction in the near-field turbulent intensities with the activation of microjets. The axial and normal turbulence intensities are reduced by about 15% and 20%, respectively, and an even larger effect is found on the peak values of the turbulent shear stress with a reduction of up to 40%. The required mass flow rate of the microjets was about 1% of the primary jet mass flux. It appears that the microjets influence the mean velocity profiles such that the peak normalized vorticity in the shear layer is significantly reduced, thus inducing an overall stabilizing effect. Therefore, we seem to have exploited the fact that an alteration in the instability characteristics of the initial shear-layer can influence the whole jet exhaust including its noise field. We have found a reduction of about 2 dB in the near-field overall sound pressure level in the lateral direction with the use of microjets. This observation is qualitatively consistent with the measured reduced turbulence intensities.