physica status solidi (a) · 1994 · 31 citations · 5 references
Natural SciencesMaterials EngineeringMaterials ScienceMaterials CharacterizationMechanical Behavior Of MaterialsSurface EngineeringIndentation PropertiesMechanical CharacterizationNon-destructive EvaluationSurface CharacterizationSurface HardnessThin Film Mechanical PropertiesDepth-sensing IndentationHardnessHardness TestingIndentation Size EffectIndentation TestingSensor TechnologyStress MeasurementSurface Layers
The characterization of the mechanical properties of surface layers produced by coating or other processing demands the measurement of the hardness at very low indentation dephts. The exact position of the zero point of the depth scale and possible tip faults, respectively, influence the reliability of the results in this region. Therefore, the elimination of such artefacts is necessary to determine the real behaviour of the material. A procedure is proposed which allows the determination of the zero point by extrapolation for two types of hardness tester, load step type, as well as closed loop type ones. Additionally an exact estimation of the standard deviation is given. A criterion allows to investigate the influence of indenter tip faults. Nominally homogeneous materials (glass, copper, polymer) show unambiguously the existence of a depth depending hardness, the so-called “indentation size effect” (ISE), as a characteristic property of the material. One must conclude that an exact analysis of the ISE for penetration depths smaller than 40 times the digit distance of the sensor system is only possible by an increase of its sensitivity.
5
W. C. Oliver, George M. Pharr · Journal of materials research/Pratt's guide to venture capital sources · 1992 · 26.6K citations
Natural Sciences, Materials Engineering, Materials Science +16