Calibration of multiple LDR brachytherapy sources

Abstract

A trend is underway toward the use of prepackaged low dose rate brachytherapy sources, which come in the form of strands, coiled line sources, preloaded needles, and sterile cartridge packs. Since the medical physicist is responsible for verification of source strength prior to patient treatment, development of prepackaged source strength verification methods is needed. Existing guidelines are reviewed to establish the situation that medical physicists find with respect to prepackaged sources. This investigation presents an experimental evaluation of the effect of some of these multiseed geometries on source strength measurements. Multiseed strands and coils, whether 125I, 103Pd, or 192Ir can be measured in a chamber with a long, sensitive axial length with a uniform response. Sterile seed cartridge packs can also be measured but require a correction factor to be applied. Sources in needles, however, cannot be measured in the needle since there is too great a variation in needle composition and needle tolerance thickness. Removing these seeds from the needle into a sterile measurement insert, which maintains sterility is a practical source strength verification method, similar to those done for multiple seed configurations in a well chamber with adequate axial uniformity. Values are compared with individual air kerma strength calibrations, and correction factors, are presented' where needed. In each case, care must be taken to maintain sterility as multiple seeds are measured in well chamber inserts.