Journal of Polymer Science Part A-1 Polymer Chemistry · 1967 · 20 citations · 2 references
Natural SciencesChemistryMaterials ScienceMaterials ChemistryPolymer ChemistryPolymer MaterialsPolymer PhysicsPolymer ProcessingPolymerization ChemistryPolymerization KineticsPolymerization ProcessesPolymerization Temperature EffectsGlassy StateIonizing IrradiationPeroxy Radical ChemistryPolymerization ReactionsRadiation-induced PolymerizationSolution PolymerizationTemperature DependenceTemperature Dependence Of Polymerization
Abstract The radiation‐induced polymerization of glass‐forming systems containing monomers has been investigated. It was found that irradiation below the second‐order transition temperature T g of the systems causes no in‐source polymerization but causes a rapid postpolymerization on warming above the T g after initial irradiation below the T g . The post‐polymerization was followed by differential thermal analysis and ESR spectra. It is caused above the T g by the release of peroxy radicals trapped below the T g , and its rate is proportional to the irradiation dose to some extent, often is explosively high, and brings about a remarkably large temperature rise by accumulation of polymerization heat. Irradiation above the T g causes rapid in‐source polymerization which is accelerated by the high viscosity of the monomeric system between T g and T s (WLF temperature) compared to crystal or ordinary solution polymerization. The temperature dependence of the in‐source polymerization of glassy systems shows a peak between the T g and T s which may be the result of competing effects of the rate increase by the decreased termination near T s and the rate decrease by the decreased propagation caused by the diffusion prevented near the T g . The degree of polymerization was also investigated. The temperature dependence of the degree of polymerization of the polymers obtained by in‐source polymerization shows a peak similar to that of the temperature dependence of conversion. Unusually large values of the Huggins constant k ' are noted between T g and T s . The degree of polymerization of the polymer obtained by post‐polymerized increases with the increase of irradiation dose and the polymerization rate; this may be the result of decreased chain transfer to nonpolymerizable components.
2