Physical Review · 1931 · 38 citations · 14 references
Natural SciencesPhysicsCombustionFluid DynamicsThermodynamicsCompressible FlowFluid PropertiesHigh-pressure ThermodynamicsCompressibilityFluid CompressibilityPhysical Properties
The writers have adjusted and extrapolated the compressibility data obtained by Bartlett and his collaborators on nitrogen, so that very accurate $p\ensuremath{-}v\ensuremath{-}T$ data from --- 70 to 600\ifmmode^\circ\else\textdegree\fi{} and up to 1200 atm. are available. A suitable graphical scheme has been devised for obtaining the derivatives ${(\frac{\mathrm{dv}}{\mathrm{dp}})}_{T}$, ${(\frac{\mathrm{dv}}{\mathrm{dT}})}_{p}$, ${(\frac{{d}^{2}v}{d{T}^{2}})}_{p}$ at any point in order that some of the physical properties of the gas can be calculated. This graphical scheme depends on the relation of $\ensuremath{\alpha}\ensuremath{\equiv}\frac{\mathrm{RT}}{p\ensuremath{-}v}$ and $\ensuremath{\Delta}\ensuremath{\equiv}v(\frac{\mathrm{pv}}{\mathrm{RT}}\ensuremath{-}1)$ to $p$, $v$, $T$, and on the relations of the derivatives of $\ensuremath{\alpha}$ and $\ensuremath{\Delta}$ to the derivatives of $v$. Errors in the estimation of the slope of an $\ensuremath{\alpha}$ or $\ensuremath{\Delta}$ curve at any point introduce much smaller errors into the derivatives of $v$, since the derivatives of $\ensuremath{\alpha}$ and $\ensuremath{\Delta}$ enter as correction terms to the derivatives of $v$ just as $\ensuremath{\alpha}$ and $\ensuremath{\Delta}$ are corrections to $v$ itself.A graphical process is used as originally in MS for adjusting the $p\ensuremath{-}v\ensuremath{-}T$ data and all the physical properties derived from it. This process is based on the assumption that surfaces such as $p\ensuremath{-}v\ensuremath{-}T$; $\ensuremath{\alpha}\ensuremath{-}v\ensuremath{-}T$; or $\ensuremath{\Delta}\ensuremath{-}v\ensuremath{-}T$ are smooth and hence that the curves in any family of isotherms or isobars show related characteristics. It throws most of the adjustment on $v$, where it belongs, since the measurements of $p$ and $T$ are much more accurate than those of $v$. Such an adjustment enhances the precision of the compressibility data and of the calculations made from it.The specific volume, density, coefficients $(\ensuremath{-}\frac{p}{v}){(\frac{\mathrm{dv}}{\mathrm{dp}})}_{T}$ and $(\frac{T}{v}){(\frac{\mathrm{dv}}{\mathrm{dT}})}_{p}$, fugacity, ${C}_{p}$, ${C}_{p}\ensuremath{-}{C}_{v}$, ${C}_{v}$, and $\ensuremath{\mu}$ are calculated and shown in curves and a table for the fourteen pressures and twelve temperatures in the range studied. Inversion pressures and temperatures are read from the $\ensuremath{\mu}$ vs. $p$ isotherms and the $\ensuremath{\mu}$ vs. $T$ isobars.The calculations of ${C}_{p}$ agree well with the experimental values of Krase and Mackey, who worked at 30, 100, 125, 150\ifmmode^\circ\else\textdegree\fi{} up to 700 atm. and at 50\ifmmode^\circ\else\textdegree\fi{} to 800 atm. The agreement is probably within the experimental error, but the trends of the two sets suggest that a real difference may exist. At 30\ifmmode^\circ\else\textdegree\fi{} the calculated ${C}_{p}$ drift below the experimental values at pressures above 400 atm., becoming 0.13 cal/mole\ifmmode\cdot\else\textperiodcentered\fi{}deg low at 700 atm. At 50\ifmmode^\circ\else\textdegree\fi{} the agreement is good to 800 atm. At 100, 125, 150\ifmmode^\circ\else\textdegree\fi{} the calculated ${C}_{p}$ drift above the experimental values, but the disagreement reaches only 0.2 cal/mole\ifmmode\cdot\else\textperiodcentered\fi{}deg at 600 and 700 atm.As one might expect, ${C}_{p}\ensuremath{-}{C}_{v}$ approaches $R$ at all temperatures as the pressure approaches zero. In general, ${C}_{p}\ensuremath{-}{C}_{v}$ increases at any particular pressure as the temperature decreases. ${C}_{p}\ensuremath{-}{C}_{v}$ shows a strong maximum at about 200 atm. at the lowest temperatures. With increasing temperature this maximum comes at higher and higher pressures, and gradually disappears. The ${C}_{v}$ vs. $T$ isobars show some curious tendencies. ${C}_{v}$ along the 20 atm. isobare stays constant and equal to 2.50 $R$ from -70 to 100\ifmmode^\circ\else\textdegree\fi{}C, then it rises slowly to 5.15 cal/mole\ifmmode\cdot\else\textperiodcentered\fi{}deg at 600\ifmmode^\circ\else\textdegree\fi{}. Along the 40, 60, 80, and 100 atm. isobars, ${C}_{v}$ drops a few hundredths of a cal/mole\ifmmode\cdot\else\textperiodcentered\fi{}deg below 2.50 $R$ at -70\ifmmode^\circ\else\textdegree\fi{}. the drop being greater the greater the pressure. Along the 200 atm and higher pressure isobars, ${C}_{v}$ rises as the temperature falls below 50\ifmmode^\circ\else\textdegree\fi{}, and the rise is steeper the greater the pressure. At 600\ifmmode^\circ\else\textdegree\fi{} ${C}_{v}$ is about 5.18 cal/mole deg or 2.61 $R$ for all pressures.
14
Edward P. Bartlett, H. L. Cupples, T. H. Tremearne · Journal of the American Chemical Society · 1928 · 66 citations