Experimental Investigation of Self-Actuating, Upper-Surface, High-Lift-Enhancing Effectors

Goetz Bramesfeld, Mark D. Maughmer

Journal of Aircraft · 2002 · 61 citations · 5 references

Concepts

TL;DR

Effectors can be installed flush on an airfoil and preserve low‑drag performance when separation is absent. In low‑speed wind‑tunnel tests at a chord Reynolds number of 10^6, 9‑% chord tabs deploy passively near stall, acting as pressure dams that raise trailing‑edge pressure and increase lift by about 20%. The higher trailing‑edge pressure produced by the tabs allows higher lower‑surface pressures, resulting in a lift‑coefficient increase of roughly 20%.

Abstract

The increase in the maximum lift of an airfoil caused by small, movable tabs mounted on its upper surface has been explored in low-speed, wind-tunnel experiments at a chord Reynolds number of 1 :0 ££ 10 6 . These devices, herein called lift-enhancing effectors, have a chord that is 9% that of the airfoil and deploy passively at angles of attack approaching stall.Compared to theclean airfoil, themaximum lift coefe cientis increased by approximately 20%withthesesimpledevices.Theliftincreaseismainlycausedbytheeffectorsactingas“ pressuredams,” allowing lower pressures upstream of their location than would occur otherwise. At an effector the pressure recovers in a stepwise manner and continues downstream toward a trailing-edge value that is higher than that of the clean airfoil. This higher trailing-edge pressure also contributes to the increase in lift by allowing higher pressures over much of thelowersurface. It has been shown that, in the absence of separation, properly installed effectors will lay e ush on the surface and allow the airfoil to have the same performance in the low-drag range as the clean airfoil.

References

5