Thermal properties of compressed expanded graphite: photothermal measurements

Abstract

The thermal diffusivity and the thermal conductivity of compressed expanded graphite (CEG) samples were investigated by photothermal measurements in two geometries differing by a place of temperature disturbance detection. This disturbance can be detected on a surface opposite to the one at which the disturbance was generated (rear detection) or on the same surface (front detection). A measurement based on the rear detection allowed us to determine the effective thermal diffusivity of the sample, while the method with front detection gives the possibility of analysis of homogeneity of the sample. It is shown that the thermal diffusivity of CEG strongly depends on its apparent density. Moreover, CEG samples reveal anisotropy of the thermal properties. The thermal diffusivity in the direction parallel to the compacting axis is lower than the one in the direction perpendicular to it. The parallel thermal diffusivity decreases with growing apparent density, while the perpendicular thermal diffusivity significantly grows when the apparent density grows. The perpendicular thermal conductivity exhibits the same behavior as the perpendicular thermal diffusivity. The parallel thermal conductivity slightly grows with growing density and then reaches a plateau. The anisotropy of CEG samples grows with growing apparent density and vanishes for low-density samples. The photothermal measurement with front signal detection revealed that the CEG samples are non-homogeneous in the direction of the compacting axis and can be modeled by a two-layer system.