Micro & Nano Letters · 2012 · 12 citations · 9 references
EngineeringMaterials ScienceMechanical EngineeringMechanical Behavior Of MaterialsNanotechnologySurface ScienceNanomechanical PropertiesNanomechanicsPlastic DeformationSilicon MaterialsSliding ContactSurface RoughnessIndentation MechanicsMechanical PerformanceMicro-contact MechanicsNanoscale Contact MechanicsScratch TestingSiliconSurface DamageTribology Of Nanostructured Surfaces
Through nanoindentation and nanoscratch tests, it is demonstrated that friction-induced protrusive nanostructures (or hillocks) showed good mechanical behaviour. At the maximum indentation depth of 2 nm, the elastic modulus of the hillocks on the silicon/quartz surface was only 5.3%/14.8% lower than that measured on their substrates. After scratching under a contact pressure of 10.3 GPa on silicon hillocks or 7.2 GPa on quartz hillocks, no surface damage was observed on the scratched area. Hence, the friction-induced hillocks can withstand typical contact in dynamic MEMS. Even though the scratch depths were much larger than the height of the detected hillocks, no peeling-off scar or surface crack could be detected beside the grooves on the hillocks, which indicated that the hillocks bonded strongly to their substrates. Further analysis revealed that the strength of the friction-induced hillocks was strongly dependent on the friction-induced process. The hillock produced at high sliding speed can lead to a high elastic modulus. Transmission electron microscope detection showed that the deformed silicon matrix formed chiefly at high sliding speed can enhance the elastic modulus of the hillocks. As a comparison, the amorphous silicon layer formed mainly at low sliding speed can reduce the elastic modulus of the hillocks.
9
Comparison of nano-indentation hardness to microhardness
Linmao Qian, Ming Li, Zhongrong Zhou et al. · Surface and Coatings Technology · 2004 · 300 citations
Natural Sciences, Materials Engineering, Materials Science +12
Friction-induced nanofabrication on monocrystalline silicon
Bingjun Yu, Hanshan Dong, Linmao Qian et al. · Nanotechnology · 2009 · 69 citations