Tensile modulus of polymer nanocomposites

Xiang Ji, Jiao Kai Jing, Wei Jiang, Bing Zheng Jiang

Polymer Engineering and Science · 2002 · 385 citations · 35 references

Concepts

TL;DR

The tensile modulus of polymer nanocomposites is strongly affected by the interfacial region, particularly when filler particles are nanosized, highlighting the need for a refined modeling approach. This study proposes a three‑phase model—including matrix, interfacial region, and fillers—to calculate the tensile modulus of polymer nanocomposites. The model assumes random distribution of spherical, cylindrical, or plate‑shaped fillers and incorporates particle size, shape, interfacial thickness, modulus ratio, and a gradient parameter, and is validated by theoretical calculations and nylon 6/montmorillonite experiments, with percolation theory applied and reduced to Takayanagi’s model for micrometer‑scale fillers. The three‑phase model shows that particle size, shape, and interfacial thickness dominate the modulus, with smaller particles producing higher modulus at a fixed volume fraction, and the predicted curves agree well with experimental results.

Abstract

Abstract Based on Takayanagi's two‐phase model, a three‐phase model including the matrix, interfacial region, and fillers is proposed to calculate the tensile modulus of polymer nanocomposites ( E c ). In this model, fillers (sphere‐, cylinder‐ or plateshape) are randomly distributed in a matrix. If the particulate size is in the range of nanometers, the interfacial region will play an important role in the modulus of the composites. Important system parameters include the dispersed particle size ( t ), shape, thickness of the interfacial region (τ), particulate‐to‐matrix modulus ratio ( E d / E m ), and a parameter ( k ) describing a linear gradient change in modulus between the matrix and the surface of particle on the modulus of nanocomposites ( E c ). The effects of these parameters are discussed using theoretical calculation and nylon 6/montmorillonite nanocomposite experiments. The former three factors exhibit dominant influence on E c . At a fixed volume fraction of the dispersed phase, smaller particles provide an increasing modulus for the resulting composite, as compared to the larger one because the interfacial region greatly affects E c . Moreover, since the size of fillers is in the scale of micrometers, the influence of interfacial region is neglected and the deduced equation is reduced to Takayanagi's model. The curves predicted by the three‐phase model are in good agreement with experimental results. The percolation concept and theory are also applied to analyze and interpret the experimental results.

References

35