Journal of Materials Engineering and Performance · 2014 · 12 citations · 3 references
EngineeringMaterials EngineeringMaterials ScienceSurface ChemistrySurface EngineeringSurface ScienceCoatingsSurface CoatingsSurface Finish QualitySurface FinishesSurface FinishingPrinted Circuit BoardsPrinted Circuit MaterialsSurface ContaminationSurface Contamination AnalysisSurface Contamination EffectsSurface Contamination MeasurementSurface Integrity AssessmentSurface Preparation Effects
The ionic contamination on printed circuit boards (PCB) having different surface finishes was examined using ionograph. The study was performed at the RT on three types of PCBs covered with: (i) hot air solder leveling (HASL LF), (ii) electroless nickel immersion gold (ENIG), and (iii) organic surface protectant (OSP), all on Cu substrates, as well as two types of fluxes, namely EF2202 and RF800. In the group of boards without soldered components, the lowest average value of contamination was for the ENIG 18 µm surface (0.01 μg NaCl/cm 2 ). Boards with soldered components were more contaminated (from 0.29 μg NaCl/cm 2 for the HASL LF 18 µm surface). After spraying boards with fluxing agents, the values of contaminants were the highest. The influence of phosphorus content in Ni-P layer of ENIG finish on ionic contamination was examined. In the group of PCBs with Au coating, the smallest amount of surface contaminants (0.32 μg NaCl/cm 2 ) was for Ni-2-5%P layer. PCBs with Ni-11%P layer were higher contaminated (0.47 μg NaCl/cm 2 ), and another with Ni-8%P layer had 0.81 μg NaCl/cm 2 . PCBs without Au coating, had the lowest contamination (0.48 μg NaCl/cm 2 ) at phosphorous content equal 11%P. Higher contamination (0.67 μg NaCl/cm 2 ) was at 2-5%P, up to 1.98 μg NaCl/cm 2 for 8% of P. Boards with Au finish have lower value of contamination than identical boards without Au layer thus contributing to better reliability of electronic assemblies, since its failures due to current leakage and corrosion can be caused by contaminants.
3
PCB failure analysis related to the ENIG black pad problem
R. Ramanauskas, Algirdas Selskis, Jurga Juodkazytė et al. · Circuit World · 2013 · 20 citations
Natural Sciences, Materials Engineering, Materials Science +17