Physica Scripta · 2014 · 19 citations · 17 references
EngineeringMaterials EngineeringMaterials ScienceHeat TransferMetallurgyNuclear MaterialsAlloysFusion Reactor MaterialsHigh-temperature MaterialsMetallic Nuclear MaterialsPlasma-surface InteractionsSuperconducting MaterialsHeat Flux ExhaustHigh-heat-flux MaterialsHigh-heat-flux TestingHigh-temperature SuperconductorsHot PressingPlasma Facing ComponentsPlasma-facing MaterialsVacuum Pressing
To upgrade the Experimental Advanced Superconducting Tokamak dome and first-wall, flat-type W/Cu plasma-facing components will be installed in the coming years in order to exhaust the increasing heat flux. Mock-ups with an interlayer of oxygen-free Cu (OFC) made by vacuum hot pressing have been developed and the bonding strength was found to be over 100 MPa. The behavior of the mock-ups under steady-state high heat flux loads has been studied. No crack or exfoliation occurred on the W surface and W/OFC/CuCrZr interfaces after screening tests with heat fluxes of 2.24–7.73 MW m−2. The mock-up survived up to 1000 cycles heat load of 3.24 MW m−2 with cooling water of 4 m s−1, 20 °C. However, cracks appeared in W around the gaps at about the 300th cycle under a heat load of 5.37 MW m−2. We have also studied the chemical vapor deposition W coated CuCrZr with an OFC interlayer. It has been found that: (i) the OFC interlayer plays a significant role in achieving coatings without any crack, (ii) the deposition rate was about 0.3–0.5 mm h−1 at 490–580 °C and (iii) a bonding strength of 53.7 MPa was achieved with laser surfi-sculpt.
17
Materials for the plasma-facing components of fusion reactors
H. Bolt, V. Barabash, W. Krauss et al. · Journal of Nuclear Materials · 2004 · 666 citations