A New Treatment for Wellbore Strengthening in Shale

Abstract

Abstract The increase in complexity and associated costs with wells as a result of infield drilling, drilling below old fields and striving for deeper targets has generated industry interest and attention in wellbore strengthening. This heightened interest is demonstrated in the number of recent publications that have been prepared on the subject. These have primarily focused on and described methods that are effective in raising the fracture resistance of permeable formations such as sands. However, a much bigger impact can be made on the overall drilling operation if it is also possible to strengthen low permeability rocks such as shale along with the sands. The industry has seen this as a major challenge and to date the technology and expertise required to achieve this has not been consistent or reliable. This paper will demonstrate that wellbore strengthening in shale is indeed feasible. A treatment pill was developed in the laboratory and successfully field tested at a US land-based location. The treatment consisted of a blend of particulates (known as stress cage solids) and proprietary cross-linked gelling polymers which set with time. Properties of the system such as compressive strength, adhesion to shale and the sensitivity to temperature and pressure were evaluated, and modeling work was done to engineer the size and concentration of bridging solids required. Field testing was carried out in a 50-ft section of competent shale below the 9⅝-in. shoe in an operation where oil-based mud was being used. The initial fracture gradient was measured using leak-off tests to establish the native formation strength. The treatment was squeezed and allowed to set under pressure before drilling out, leaving a strengthened wellbore. Formation Integrity Tests (FIT) were conducted to confirm the presence of the strengthening effect. The robustness of the treatment was demonstrated by circulating drilling fluid for increasing periods of time and performing further FIT tests. The well was left in a strengthened state at the end of the test period. This trial demonstrates that by using appropriate technologies and methods it is indeed possible to reliably raise shale fracture resistance.