Nucleation parameter and size distribution of critical nuclei for nonisothermal polymer crystallization: The influence of the cooling rate and filler

Nikola Kocic, Sara Lederhofer, K. Kretschmer, Martin Bastian, Peter Heidemeyer

Journal of Applied Polymer Science · 2014 · 14 citations · 38 references

Concepts

Abstract

ABSTRACT The nucleation parameter K g of filled PP, HDPE, and PA6 is determined through nonisothermal DSC measurements. A novel method is proposed for the determination of the size distribution of critical nuclei, where the most commonly found fraction was obtained as a peak value. The models are tested at different cooling rates and different filler loadings. K g varies up to a certain cooling rate and afterwards remains constant. The introduction of talc in PP and HDPE facilitates nucleation and thus reduces K g . An opposite trend occurs upon the addition of bentonite in PA6. The changes of K g and are reflected on sample morphology, as confirmed with SAXS. The ratio between the final crystal thickness and amounts to approx. 2 and thus agrees well with the one listed in literature. The simple linear correlations of the obtained K g are established with Young's modulus and yield stress. © 2014 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2015 , 132 , 41433.

References

38