Processing of highly elastomeric toughened cyanate esters through a modified resin transfer molding technique

Abstract

Abstract Model cyanate ester resins containing different quantities of epoxy functional butadiene‐acrylonitrile rubber (ETBN) to improve the fracture performance were developed as matrices for composites. With the elastomeric modification, the resin systems exhibited rheological characteristics inappropriate for laminate fabrication by conventional resin transfer molding (RTM). To fabricate the carbon fiber based laminates in one liquid molding operation successfully, a process named bleed resin transfer molding (BRTM) was established. The BRTM process combines features of RTM and resin film infusion processes (RFI) and was therefore appropriate for processing high viscosity matrix resins. A novel catalyst was selected for the cyanate ester resin that provided enough latency for the impregnation steps in the BRTM process. Through the use of thermal analytical tools, a high degree of phase separation and conversion was obtained. The conversion and the glass transition temperature were found not to decrease with increasing elastomer content, which is in contradiction to most toughening modifications. Mode I and Mode II interlaminar fracture toughness were found to increase significantly with increasing elastomer content. In Mode I, an increase of up to 140% was observed. Collectively, this work showed that through the use of the BRTM technique, matrices with toughness improvements usually only achieved by prepreg systems can be processed in an RTM‐like manner.