SPE Annual Technical Conference and Exhibition · 1981 · 33 citations · 6 references
EngineeringEarth SciencesPetroleum EngineeringReservoir EngineeringWell LoggingWell TestingPermeability EstimationPermeability EvaluationProduction LoggingWell Log InterpretationWell Performance AnalysisWell Test AnalysisBottomhole Pressure AnalysisPermeability Distribution AnalysisProduction Log InterpretationReservoir DescriptionReservoir Pressure ResponseSkin Factor AnalysisSkin Factor EstimationTransient Pressure Response
ABSTRACT In the paper the quantitative interpretation of production logs, i.e. simultaneous recordings of bottom-hole flow profile and pressure, using a vertically distributed single well model (VDSWM) is described. In this approach a production log is run in the steady flow period preceding a well shut-in and then again, where necessary, during the closed-in period in order to detect any layer crossflow through the well-bore. The local reservoir description i.e. individual layer permeabilities and damage/perforation skin factors are then systematically altered from initial estimates until the predictions of: the flow profile and drawdown during the flow period,the transient pressure response and layer crossflow during shut-in, from the single well simulation match the corresponding measurements. The initial estimate of permeability distribution is obtained from the open-hole logs using a zonation algorithm and a permeability transform calibrated with core data from key wells. Thus conventional well test analysis, which typically deals with overall average permeability and skin factor, is extended to give estimates of these quantities on a layer-by-layer basis by matching the flow distribution as well as the pressure response. The main objective is to identify, firstly, layers whose effective permeability is greater than the value indicated from core/log studies i.e. potential thief zones with anomalous characteristics and, secondly, completion problems associated with groups of perforations which do not flow. The VDSWM allows the synergetic interpretation of data from several sources viz open-hole logs and cores, production logging, transient well testing and RFT* pressure surveys to obtain a layered reservoir description which is as realistic as possible. Given this model it is shown how the steady-state inflow performance of the well, in the situation where the layers have depleted to different potentials, can be represented by partial productivity index matrices which when multiplied by the vector of layer drawdowns yield either the layer flows at the sand-face or at the external face of the radial flow region surrounding the well; these are different due to near well-bore flow convergence. These matrix formulations can be used as the lumped parameter single well models in layered reservoir simulators on the basis of the concept of the equivalent block radius of Peaceman (15) generalized to a layered system.
6
The Effect of Small, Discontinuous Shales on Oil Recovery
J.G. Richardson, Donald G. Harris, R.H. Rossen et al. · Journal of Petroleum Technology · 1978 · 80 citations