Dental Materials Journal · 2007 · 143 citations · 17 references
DentistryDental Biomaterials ScienceDental Materials ScienceDental MaterialsProsthodontic BiomaterialsProsthodontic MaterialsBridge MaterialsCrown MaterialsDental CementsDental CeramicsCad And Cam Dental CeramicsCad And Cam Dental MaterialsCement Layer ThicknessCeramic FrameworksMarginal Gap AnalysisZirconia CeramicsZirconia MaterialsZirconia-based Restorations
The aim of this study was to investigate the effect of post-machining sintering on marginal and internal fit of CAD/CAM-fabricated zirconia frameworks. Single crown copings (A: abutment), three-unit bridge frameworks (APA, P: pontic), four-unit bridge frameworks (APPA), and five-unit bridge frameworks (A1P1A2P2A3) were fabricated with raw-stage zirconia blanks using a commercial CAD/CAM system (KATANA, Noritake Dental Supply Co. Ltd., Aichi, Japan). Crown copings and frameworks were cemented to their respective master abutment models, and thickness of the cement layer was measured at specific measuring points. Marginal and internal fit of both APA and APPA were within clinical acceptance. However, the marginal gap and thickness of the cement layer on the axial surface of the pontic side of APA and APPA were slightly higher than those of the non-pontic side. As for the marginal gap of A1P1A2P2A3 framework, it was superior to those of APA and APPA because the center abutment supported the framework to prevent distortion.
17
Effect of in vivo crown margin discrepancies on periodontal health
David A. Felton, B.E. Kanoy, Stephen C. Bayne et al. · Journal of Prosthetic Dentistry · 1991 · 425 citations