Langmuir · 1997 · 200 citations · 16 references
Natural SciencesMaterials EngineeringMaterials SciencePolymer ChemistryPolymer EngineeringThin FilmsNucleationPolymer MorphologyPolymer PhysicsPolymer Thin FilmsSpinodal DecompositionThin Film NucleationDefect FormationDelaminationDelamination-induced BucklingDewetting PhenomenaParticle NucleationPolymer Thin Film DewettingThin Film DewettingThin Liquid Films
Scanning probe microscopy is used to image nucleation sites leading to dewetting of polystyrene films (<25 nm) from nonwetting Si substrates. Images outline the progression of nucleation until a hole or dry patch is formed. Both spinodal decomposition and particle nucleation are observed to initiate dewetting. Spinodal decomposition appears as surface indentations that grow exponentially with time. Indentation growth rate is measured using an “anneal-quench-image” cycling procedure. Under clean room conditions spinodal decomposition dominates the nucleation process while particle nucleation increases in higher aerosol concentration environments. Upon thermal cycling of the films a third type of nucleation emerges resulting from delamination-induced buckling of the polystyrene film. The three mechanisms of defect formation are described and compared to theories of defect formation during drying of thin liquid films on nonwetting substrates.
16
Physical chemistry of surfaces
Patrick R. Taylor · Colloids and Surfaces · 1991 · 2.8K citations
Dewetting of thin polymer films
Günter Reiter · Physical Review Letters · 1992 · 1.1K citations
Natural Sciences, Materials Engineering, Materials Science +12
Dewetting of thin polymer films
Thomas Vilmin, Élie Raphaël · The European Physical Journal E · 2006 · 963 citations
Natural Sciences, Materials Engineering, Materials Science +12
C. Redon, Françoise Brochard‐Wyart, F. Rondelez · Physical Review Letters · 1991 · 534 citations
Natural Sciences, Materials Engineering, Materials Science +17
Unstable thin polymer films: rupture and dewetting processes
Langmuir · 1993 · 500 citations
Natural Sciences, Materials Engineering, Materials Science +16