The Philosophical Magazine A Journal of Theoretical Experimental and Applied Physics · 2005 · 81 citations · 26 references
Natural SciencesMaterials EngineeringMaterials ScienceMaterials CharacterizationMechanical Behavior Of MaterialsMetallurgyAlloysCreep BehaviorCreep DeformationDeformation MechanismsMetalsStress-strain BehaviorAlloy Creep BehaviorCreep MechanismsCreep Under Strain RateDislocationsTemperature-dependent CreepTitanium AlloysTitanium MaterialsYield Stress
Titanium alloys are known to creep at room temperature at stresses below the macroscopic yield stress. In this study a two-phase α/β alloy, Ti-6Al-2Sn-4Zr-2Mo (Ti-6242), and a single phase binary alloy, Ti-6Al, were observed to exhibit a dramatic asymmetry between tension and compression during room temperature creep. It was observed that the aero-engine alloy, Ti-6242, accumulated about five to six times higher creep strains in tension than in compression. A much smaller asymmetry was observed for the 0.2% yield strength such that it is higher in compression. It is shown that the present observations cannot be explained by the activation of predominantly ⟨c + a⟩ slip. Further, CRSS measurements from single colony crystals of Ti-6242Si oriented for basal ⟨a⟩-type slip showed that there is a significant asymmetry between tension and compression, with the CRSS observed to be higher in compression. Studies on the single-phase α alloy Ti-6Al with low oxygen content suggest that the interstitial content could also play a significant role in determining the behaviour of these alloys. The single phase alloy also exhibited tension-compression asymmetry in creep, although it was observed to be less pronounced compared to the two phase alloy. HRTEM results suggest that the core structure of ⟨a⟩-type dislocations is altered by the addition of alloying elements, especially oxygen, and that the tension–compression asymmetry is primarily due to the behaviour of ⟨a⟩-type dislocations.
26
Plastic anisotropy in b.c.c. transition metals
M. S. Duesbery, V. Vítek · Acta Materialia · 1998 · 509 citations · Full text
Natural Sciences, Materials Engineering, Materials Science +17
Titanium science and technology
H.M. Flower · Materials & Design (1980-2015) · 1986 · 449 citations
Deformation and creep modeling in polycrystalline Ti–6Al alloys
Vikas Hasija, Somnath Ghosh, Michael J. Mills et al. · Acta Materialia · 2003 · 347 citations
Natural Sciences, Materials Engineering, Materials Science +14