Transactions of the ASAE · 2005 · 29 citations · 0 references
EngineeringBiotechnologyEnvironmental EngineeringBiochemical EngineeringResource RecoveryWastewater TreatmentAnaerobic DigestionBiogas ProductionOrganic Waste RecoverySequencing Batch ReactorsSludge TreatmentWaste TreatmentAnaerobic Sequencing Batch ReactorsAnimal Waste ManagementBiogasBiogas Yield OptimizationManure Management SystemsProcess Optimization In Anaerobic DigestionSlurriesWaste Treatment Systems
Use of anaerobic digestion for the treatment and recovery of biogas from concentrated animal waste effluents isa technically viable approach, but widespread acceptance has been limited due to poor economics. This challenge ismagnified several-fold when considering anaerobic digestion of low-strength or dilute animal slurries because of the largerdigester volumes and the corresponding high energy input requirements. These constraints could be mitigated by using ananaerobic sequencing batch reactor (ASBR). This technology has shown tremendous potential to improve the economics forthe treatment of dilute animal waste effluents. This article reports preliminary optimization (biogas production and organicstrength reduction) of an ASBR treating dilute swine slurries from pit-recharge manure management systems commonly foundin confined swine housing. Based on the results, optimum biogas yields from anaerobic digestion of low-strength swine waste(0.3% to 0.4% TS) were approximately 0.14 mL/mg COD and 0.16 mL/mg COD at 5.25 and 6 days HRT at digestiontemperatures of 20C and 35C, respectively. Higher operational temperature improved the specific biogas yield, but thequalities of biogas produced at the two temperatures, although high (65% to 70% CH4 and 17% to 20% CO2), were notsignificantly different. Maximum COD reductions of approximately 90% and 84% would be achieved at 7.2 and 9.1 days HRTat digestion temperatures of 20C and 35C, respectively. Higher COD reduction (implying more bio-stabilization of slurry)in the lower-temperature digester was attributed to less biomass washout, which is likely due to more efficient solids settling.The volatile fatty acids at both reactor temperatures were reduced from a mean of 639 75 mg/L in the influent to mean valuesof 74 12 and 85 17 mg/L in the effluents at 20C and 35C, respectively, which significantly mitigated the potential ofodor generation from the effluents. Additionally, it was observed that the nutrient (both N and P) levels in the effluentsremained about the same as in the influent.