Journal of Applied Polymer Science · 2012 · 12 citations · 10 references
EngineeringMaterials EngineeringMaterials ScienceMechanical Behavior Of MaterialsPolymer EngineeringPolymer MaterialsInjection MoldingPolymer ProcessingPolymer ProductionActivated CarbonCycle TimeCycle Time ControlInjection Molding TechniqueMicrocellular Injection MoldingPorositySupercritical Fluids
Abstract In this article, a novel approach to decrease cycle time without compromising part dimensional stability developed in our group is compared with the use of supercritical nitrogen in injection molding. In this new approach, water is pre‐pressurized into the polymer pellets containing water carrier particles such as activated carbon (AC), thus no molding equipment modifications are required. Because of its high porosity, AC can trap water inside the particle, thus improving water compatibility with hydrophobic polymers for less water loss during handling and in the barrel during injection molding. After mixing, the polymer with the water carrier, the pellets are batch pressurized with water at a controlled temperature and pressure. The water containing pellets are then fed into the hopper of the injection molding machine. Parts with similar densities were molded and mechanical properties and warpage for both processes compared. It was found that the warpage and mechanical properties of the method presented here are comparable with the use of supercritical nitrogen, which is used in microcellular injection molding. © 2012 Wiley Periodicals, Inc. J. Appl. Polym. Sci., 2013
10
Adsorption surface area and porosity
William A. Steele · Journal of Colloid and Interface Science · 1983 · 7.9K citations
Porosity in granular carbons activated with phosphoric acid
M. Molina‐Sabio, F. Rodrı́guez-Reinoso, Francisco Caturla et al. · Carbon · 1995 · 322 citations