Q estimation from vertical seismic profile data and anomalous variations in the central North Sea

Abstract

Abstract Four different methods of estimating Q from vertical seismic profile (VSP) data based on measurements of spectral ratios, pulse amplitude, pulse width, and zeroth lag autocorrelation of the attenuated impulse are described. The last procedure is referred to as the pulse-power method. Practical problems concerning nonlinearity in the estimating procedures, uncertainties in the gain setting of the recording equipment, and the influence of structure are considered in detail. VSP data recorded in a well in the central North Sea were processed to obtain estimates of seismic attenuation. These data revealed a zone of high attenuation from approximately 4 900 ft to 5 600 ft with a value of 25 + or - 3. Results of the spectral-ratio analysis show that the data conform to a linear constant Q model. In addition, since the pulse-width measurement is dependent upon the dispersive model adopted, it is shown that a nondispersive model cannot possibly provide a match to the real data. No unambiguous evidence is presented that explains the cause of this low Q zone. However, it is tentatively concluded that the seismic attenuation may be associated with the degree of compaction of the sediments and the presence of deabsorbed gases.