Advances in Cement Research · 2004 · 20 citations · 8 references
EngineeringMaterials EngineeringMaterials ScienceBuilding MaterialsCeramic MaterialsGeotechnical EngineeringCementitious MaterialsConcrete MaterialsSilicate MineralsAlkali TreatmentCementing TechnologyCompressive StrengthCorrosion Product FormationGeothermal CorrosionSlag CementSlag-based Cementitious MaterialsTemperature Effects On Cementing
This paper evaluates the usefulness of sodium-silicate-activated slag (SSAS) cement for completing geothermal wells containing highly concentrated H 2 SO 4 and some CO 2 · Using a 20wt% sodium silicate solution (SiO 2 /Na 2 O mol ratio of 3·22) as the alkali activator, the SSAS cements autoclaved at temperatures up to 200°C displayed an outstanding compressive strength of more than 80 MPa, and a minimum water permeability of less than 3·0 × 10 −5 darcy. The combination of calcium–silicate–hydrate (C–S–H) and tobermorite phases was responsible for strengthening and densifying the autoclaved cement. At 300°C, an excessive growth of wellformed tobermorite and xonotlite crystals generated an undesirable porous microstructure, causing the retrogression of strength and enhancing water permeability. Although all the phases formed in the autoclaved cements were vulnerable to reactions with H 2 SO 4 , so depositing bassanite scales as corrosion product over the cement's surfaces, the C–S–H phase played an important role in retarding the rate of acid erosion. Thus, after the uptake of Ca by the H 2 SO 4 , Ca-destitute C–S–H preferentially reacted with the Mg from the slag to form the lizardite phase that not only retarded the rate of acid erosion, but also retained the integrity of the cementitious structure. Therefore, SSAS cement has good potential as an acid-resistant geothermal well cement at temperatures up to 200°C.
8
Autoclave properties of kirschsteinite-based steel slag
Guangren Qian, Darren Delai Sun, Joo Hwa Tay et al. · Cement and Concrete Research · 2002 · 66 citations